Intended Use; Declaration Of Conformity; Noise/Vibration Information - Bosch 0 607 450 626 Bedienungsanleitung

OBJ_BUCH-281-001.book Page 17 Thursday, October 26, 2006 10:40 AM

Intended Use

The pneumatic tool is intended for the screwing in and
loosening of bolts and screws as well as for the tight-
ening and loosening of nuts in the specified dimension
and performance range.
Other applications, e.g., drilling, stirring, sanding, etc.,
are not permitted.

Noise/Vibration Information

Measured sound values determined in accordance with EN ISO 15744.
Measured vibration values determined in accordance with EN 28662
and EN ISO 8662.
Typically, the A-weighted sound pressure level of the product is
Sound pressure level
Sound power level
Uncertainty K=
Wear hearing protection!
Overall vibrational values (vector sum of three directions) determined
according to EN 60745:
Tightening of bolts and nuts of the maximum permitted size:
Vibrational emission value a
h
Uncertainty K=
The vibration emission level given in this information sheet has been measured in accordance
WARNING
with a standardised test given in EN 60745 and may be used to compare one tool with another.
The vibration emission level will vary because of the ways in which a power tool can be used and may increase
above the level given in this information sheet. This could lead to a significant underestimate of exposure when
the tool is used regularly in such a way.
Note: To be accurate, an estimation of the level of exposure to vibration experienced during a given period of
work should also take into account the times when the tool is switched off and when it is running but not actually
doing the job. This may significantly reduce the exposure level over the total working period.
3 609 929 B04 • 26.10.06

Declaration of Conformity

We declare under our sole responsibility that this prod-
uct is in conformity with the following standards or stan-
dardization documents: EN 792, according to the pro-
visions of the directive 98/37/EC.
Dr. Egbert Schneider Dr. Eckerhard Strötgen
Senior Vice President Head of Product
Engineering Certification
04.10.2006, Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
0 607 450 ... ... 626 ... 627 ... 628
dB(A)
dB(A)
dB
2
m/s
2
m/s
99 99 97
110 110 108
3 3 3
4.5 4.5 5
1.5 1.5 1.5
English | 17