Operation Of The Music Module - GUTMANN CARTA 7500 Bedienungsanleitung

6. OPERATION OF THE MUSIC MODULE

(Only available if CARTA is equipped with the "Bluetooth Music Module" option)
Connect:
Use your Bluetooth enabled device to search for new Bluetooth
devices in the immediate vicinity of the hood. You will find a
Bluetooth device with the name: "SHAIBANG".
Connect your end device to this Bluetooth device.
Use music module:
If you select the SHAIBANG device as the output device, all media outputs of your de-
vice will be played through the hood.
Attention: Depending on the setting, incoming calls can now also be output via the co-
ver. Make sure that the settings on your terminal device are selected so that your calls
are played back as desired.
Cancel connection:
Go to the Bluetooth settings of your mobile device and disconnect the "SHAIBANG"
output device there. Now the output via the hood is no longer possible.
If you now want to play music again, you must pair the devices again.
Troubleshooting:
What to do if the "SHAIBANG" adapter is not found:
Disconnect the hood from the power supply for a short time and then reconnect it. After
restarting, the Bluetooth adapter will also reset itself and can now be found again by
new devices and connected to them.
General principles:
Once the music module is connected to a device, it is no longer visible and cannot be
connected to other devices until the hood has been de-energized. Once paired, the
device remains in the Bluetooth device list and several devices (mobile phone, iPad,...)
can be used for playback. However, only one active connection is possible at a time.
Android has two functions: Disconnect and Decouple. Disconnect is the correct func-
tion here. The connection is disconnected, the music module remains in the Bluetooth
device list and can be selected again if required. With the Decouple command, the
music module is deleted from the list and can only be reconnected if the hood was de-
energised.
IOS can be disconnected without any problems. The music module remains in the
Bluetooth device list and can be selected if required
Note :
If several devices are paired, it is important that the Bluetooth connection of already
paired devices is switched off.
Otherwise a connection will be established automatically after power recovery and the
music module will not be visible for the other devices.
Attention !
Listening to music too loud causes damage to your hearing,
so make sure you play the music at a comfortable volume. If
the music is set too loud, sound distortions can occur which
impair the enjoyment of hearing.
OPERATING INSTRUCTIONS
EN
31