Product Range - 3M Peltor Tactical XP MT1H7*2-50 serie Gebrauchsanweisung

Adjusting the headband
(E:8) Open the headband.
(E:9) Tilt the top of the shell out, as the wire must be placed on the outside of the headband. Slide out the shells
and place the hearing protectors over your ears so the ear cushions enclose the ears completely and fit snugly
against the head.
(E:10) Adjust the height of the shells for a comfortable fit while holding the headband flat against your head.
(E:11) The headband should lie across the top of the head.
IMPORTANT! For the best protection, brush aside hair around the ears so the ear cushions fit snugly against the
head. Spectacle frames should be as thin as possible and fit close to the head.
INSTRUCTIONS FOR USE (F)
Switching On and Off
Press the centre/mode button and hold for at least 2 seconds.
Increase/Decrease the volume of the level dependent function
Press the upper (+) button to increase. Press the lower (-) button to decrease.
Adjusting the balance
Press the mode button until the ghost voice says balance. Adjust the balance, to the right or to left, by using the (+)
button and (-) button. Press the (+) button and (-) button at the same time.
to reach centre balance.
Equalizer
Press the mode button until ghost voice says equalizer. Use the (+) button and (-) button to adjust the equalizer.
Available settings are: Low, Neutral, High and Extra High.
Adjusting the release time of the level dependent function
Press the mode button until the ghost voice says release time. Adjust the release time by using the (+) button and
(-) button. Available settings are: Normal and Slow.
Adjusting external input mode (headsets only)
Press the mode button until the ghost voice says external input mode. Change external input mode by using the (+)
button and (-) button. Available settings are: 1, 2 and 3. Setting 1 is optimal for professional communication radios.
Setting 3 is optimal for devices such as DECT- and mobile phones. Try different modes until you find the optimal
for your communication device.
Adjusting the volume for external input
Press the mode button until the ghost voice says external input volume. Adjust the volume by using the (+) button
and (-) button. Available settings are: normal and high. WARNING - At setting high the volume may exceed 82 dB.
NOTE - The setting of high volume for external input is not stored when the headset is switched off.

PRODUCT RANGE

Neckband
Helmet attachment
Headband collapsible MT1H7F2-50
STORAGE (G)
Do not store this hearing protection in temperatures exceeding +55°C, for example behind a windscreen or a window.
Remove the batteries when storing the hearing protector for a long time.
Storing in damp environments
When used under normal conditions perspiration and condensation makes the foam inside the product become
damp. The electronics on the inside of the product can become damaged due to this moisture.
Check the inside of the product regularly for moisture. If the product is damp on the inside, remove the hygiene kit
and let the product dry out, e.g. overnight. If this is not enough for the product to become dry it is recommended to
use two hygiene kits and change between.
Standard Weight Headset
MT1H7B2-50 375
MT1H7P3E2-50 425
390
Weight
MT1H7B2-07-50 385
MT1H7P3E2-07-50 435
MT1H7F2-07-50 400
153