Wall Mounting - Sanus VLF220 Montageanleitung

2

Wall Mounting

2-1
Locate studs
41 - 61 cm
(16 - 24 in.)
2-2
Mark the wall
2-3
Drill pilot holes
2-4
Tighten lag bolts
[17]
[16]
(6901-002111 <02>)
Wood stud mounting
< 16 mm
(5/8 in.)
[02]
[02]
Locate studs. Verify the center of the stud(s) using an awl. a thin nail,
or an edge to edge stud finder.
CAUTION:
Avoid potential personal injuries and property
damage!
Any material covering the wall must not exceed 16 mm (5/8 in.).
Ù
Minimum wood stud size: common 51 x 102 mm (2 x 4 in.)
Ù
(nominal 38 x 89 mm (1.5 x 3.5 in.))
For assistance in determining wall plate location, see Height Finder at
sanus.com.
Level the wall plate [02] and mark the hole locations. NOTE: TV will
shift 82.5 mm (3.5 in.)to the right when in the home position. Consider
this when selecting the location of your wall mount.
[02]
Drill pilot holes as illustrated.
Pilot holes MUST be drilled to a depth of 89 mm (3.5 in.), using a 5.5
mm (7/32 in.) diameter drill bit.
CAUTION:
Avoid potential injuries or property damage!
Improper use could reduce the holding power of the lag bolt. To
avoid potential injuries or property damage:
DO NOT over-tighten the lag bolts [17].
Ù
Tighten the lag bolts only until the washers [16] are pulled
Ù
firmly against the wall plate [02].
13 mm 5.5mm
(1/2 in.) (7/32 in.)
82.5 mm
3.25 in.
89 mm
(3.5 in.)
[01]
7