LaserLiner Cubus Bedienungsanleitung Seite 14

– Under no circumstances should optical instruments (magnifying glass,
microscope, binoculars) be used to look at the laser beam or reflections.
– Do not use the laser at eye level (1.40 ... 1.90 m)
– Reflective, specular or shiny surfaces must be covered whilst laser
devices are in operation.
– In public areas shield off the laser beam with barriers and partitions
wherever possible and identify the laser area with warning signs.
Safety instructions
Dealing with electromagnetic radiation
– The measuring device complies with electromagnetic compatibility
regulations and limits in accordance with the EMC Directive 2014/30/EU.
– Local operating restrictions – for example, in hospitals, aircraft, petrol
stations or in the vicinity of people with pacemakers – may apply.
Electronic devices can potentially cause hazards or interference or be
subject to hazards or interference.
Special product features and functions
The rotary laser aligns itself automatically. It is set to the required
initial position (to within an operating angle of ± 4°) and the automatic
system then performs the necessary fine adjustment, with three electronic
measurement sensors detecting the X, Y and Z axes.
The anti-drift system (ADS) prevents erroneous or inaccurate
measurements. How it works: continuous monitoring of the alignment of the
laser is activated 30 seconds after the ADS is switched on. If the device moves
due to the influence of external factors or the laser loses its height reference,
the laser will come to a standstill. Additionally, the laser flashes and the tilt
LED is lit continuously. To continue working, press the tilt button again or switch
the device off then on again. Erroneous and inaccurate measurements are
thus prevented simply and reliably.
The ADS is not active following switch-on. Once the device has
been set up, press the tilt button to activate the ADS, enabling you to protect
the laser from changes in position caused by the device being disturbed by
external factors. The tilt LED flashes to indicate that the ADS function is
active; see the diagram below.
14
EN