Parkside PBSG 95 C3 Originalbetriebsanleitung Seite 8

Non-skid footwear is recommended when
working outdoors.
Wear protective hair covering to contain
long hair.
9. Use protective equipment
Use safety glasses.
Use face or dust mask if working operations
create dust.
10. Connect dust extraction equipment
If the tool is provided for the connection of
dust extraction and collecting equipment,
ensure these are connected and properly
used.
11. Do not abuse the cord
Never yank the cord to disconnect it from
the socket. Keep the cord away from heat,
oil and sharp edges.
12. Secure work
Where possible use clamps or a vice to hold
the work. It is safer than using your hand.
13. Do not overreach
Keep proper footing and balance at all
times.
14. Maintain tools with care
Keep cutting tools sharp and clean for
better and safer performance.
Follow instruction for lubricating and chang-
ing accessories.
Inspect tool cords periodically and if dam-
aged have them repaired by an authorized
service facility.
Inspect extension cords periodically and
replace if damaged.
Keep handles dry, clean and free from oil
and grease.
15. Disconnect tools
When not in use, before servicing and
when changing accessories such as blades,
bits and cutters, disconnect tools from the
power supply.
8 GB/CY
16. Remove adjusting keys and
wrenches
Form the habit of checking to see that keys
and adjusting wrenches are removed from
the tool before turning it on.
17. Avoid unintentional starting
Ensure switch is in "off' position when
plugging in.
18. Use outdoor extension leads
When the tool is used outdoors, use only
extension cords intended for outdoor use
and so marked.
19. Stay alert
Watch what you are doing, use common
sense and do not operate the tool when
you are tired.
20. Check damaged parts
Before further use of tool, it should be
carefully checked to determine that it will
operate properly and perform its intended
function.
Check for alignment of moving parts,
binding of moving parts, breakage of parts,
mounting and any other conditions that
may affect its operation.
A guard or other part that is damaged
should be properly repaired or replaced by
an authorized service centre unless other-
wise indicated in this instruction manual.
Have defective switches replaced by an
authorized service centre.
Do not use the tool if the switch does not
turn it on and off.
21. Warning
The use of any accessory or attachment
other than one recommended in this instruc-
tion manual may present a risk of personal
injury.