Basic; Connecting The Magnification Feature Pack To The Optelec Clearreader; Magnification Views; Page View - Optelec ClearReader+ Basic Bedienungsanleitung

+
Optelec ClearReader

Basic

+

Connecting the Magnification Feature Pack to the Optelec ClearReader

Basic
+
Connect the Magnification Feature Pack to the ClearReader Basic and optionally, a monitor.
+
Locate the HDMI connector at the bottom rear side of the ClearReader Basic. If the HDMI
connector is not visible, you will need to remove the protection cover which will also reveal two
USB connectors. Use a Philips screwdriver to remove the screw which closes the cover. This
+
screw is located in the middle of the cover at the bottom side of the ClearReader Basic. Connect
+
the monitor to the ClearReader Basic by using a HDMI cable. Adjacent to the HDMI connector,
+
there are two USB ports. Connect the USB cable of the ClearReader Basic Magnification Feature
Pack to one of the two USB ports on the rear side or to the USB port on the right side of the unit.
+
When the Magnification Feature Pack is connected to the ClearReader Basic, switch on the
+
ClearReader Basic and take a snapshot of a document as described in this manual.

Magnification views

+
With the ClearReader Basic Magnification Feature Pack, you can view captured documents in
four different Views: Page view, Column view, Line view and as a full page Overview. To switch
between the different views, press the View button on the Magnification Feature Pack.

Page View

The Page view shows a photograph of the document in its original layout, including the pictures.
English 34