Inhaltsverzeichnis
Werbung
en
Connecting the
appliance
After installing the appliance, wait at least
½ hour before switching on the appliance.
During transportation the oil in the
compressor may have flowed into the
refrigeration system.
Before switching on the appliance for the
first time, clean the interior (see Cleaning).
The socket should be freely accessible.
Connect the appliance to
220-240 V/50 Hz alternating current
via a correctly installed earthed socket.
The socket must be fused with a 10 A to
16 A fuse.
If the appliance is to be operated
in a non European country, check
on the rating plate whether the
indicated voltage and current type
correspond to the values of your
mains supply. The rating plate
is situated in the bottom left hand side
of the appliance. The mains
connection cable may be replaced by
an electrician only.
Warning!
!
Never connect the appliance
to electronic energy saver plugs or to
power inverters which convert the
direct current to 230 V alternating
current (e.g. solar equipment, power
supplies on ships).
24
Switching on the
appliance
Fig. 2
Press main switch 1.
The flashing temperature indicator light
changes from a flashing to a steady light
when the operating temperature is
reached. Interior light is switched on
when the door is open.
At the factory the refrigerator
compartment was set to +6 ºC.
Werbung
Inhaltsverzeichnis
