How To Make Ice Cubes; Some Useful Information And Advice; Hints And Ideas; How To Save Energy - Zanussi zrt 15 jc Gebrauchsanleitung

GB
the refrigerator. This way foods will keep their
moisture e.g. vegetables will not dry out after some
days.

How to make ice cubes

To make ice cubes fill the enclosed ice cube tray with
water and put it to the frozen food compartment. Wetting
the bottom of the tray and setting thermostatic control
knob to maximum stage can shorten preparing time. After
finishing do not forget to reset the thermostatic control to
the suitable stage.
Ready ice cubes can be taken out of the tray under
running water then twist or hit it.

Some useful information and advice

The variable shelves are worth paying attention to,
which increases the usefulness of the fresh food
compartment considerably. Rearranging the shelves is
also possible when the door is open at an angle of 90°.
The inside configuration of the door makes rearranging
the door shelves as required possible.

Hints and ideas

In this chapter practical hints and ideas are given about
how to use the appliance to reach maximum energy
saving and there is environmental information about the
appliance as well.

How to save energy

The colder the ambient temperature of the appliance
is the less energy it uses.
Avoid putting the appliance in a sunny place and near
anything that gives off heat.
Be sure that the condenser and the compressor are
well ventilated. Do not cover the sections where
ventilation is.
Wrap products in tightly closing dishes or cling film to
avoid building up unnecessary frost.
Do not leave the door open longer than necessary
and avoid unnecessary openings.
When closing the door of the frozen food
compartment take care to move its bolt in the
direction of the arrow to fit it to the lock properly.
Put foods into the appliance only in a closed dish.
Put warm foods into the appliance only when they are
at room temperature.
Keep the condenser clean at the back of the
appliance.
44

The appliance and environment

This appliance does not contain gasses which could
damage the ozone layer, in either its refrigerant circuit or
insulation materials. The appliance shall not be discarded
together with the urban refuse and rubbish. Avoid
damaging the cooling unit, especially at the rear near the
heat exchanger. Information on your local disposal sites
may be obtained from your municipal authorities.
The materials used on this appliance marked with the
sympol are recyclable.

Maintenance

Defrosting

Bleeding part of the moisture of cooling chamber in form
of frost and ice goes with the operation of the refrigerator.
Thick frost and ice has an insulating effect, so it reduces
cooling efficiency as the temperature increases, it needs
more energy, at a certain thickness it does not allow the
door of the frozen food compartment to open, possibly
the door can be broken.
At this type of appliance defrosting fresh food
compartment is automatic without any external
intervention.
The thermostatic control interrupts the operation of
compressor at regular intervals for more or less time -
during this cooling is interrupted - temperature of the
fresh food compartment increases and defrosting
occurs. After defrosting the thermostatic control restarts
operation of the system.
Melting water flows through defrost water outlet into the
evaporative tray maintained on the top of compressor and
evaporates due to warmth of it.
Check and clean the outlet of melting water
coming during defrosting regularly. If it is
clogged the melting water gathered can cause
earlier failure as it can go to the insulating of the
appliance.
Clean the melting water outlet with the supplied pipe
scraper that can be seen in the figure. The pipe scraper
has to be stored in the outlet.
Occasionally check defrost water outlet not to be
clogged up.
The most typical case of clogging up in the defrost water
outlet when you put food wrapped in some paper into the