How To Use The Cooling Compartment; Some Useful Information And Advice; Hints And Ideas; How To Save Energy - Zanussi ZRA 626 CW Gebrauchsanleitung

GB

How to use the cooling compartment

Developing interior air circulation is necessary for
adequate cooling. For this reason you are asked not to
cover the whole surface of the wire shelves with paper, trays,
etc.
Do not put hot food into the refrigerator. Allow it to
reach room temperature naturally. In this way
unnecessary frost building up can be avoided.
Foods can take over odours from each other. So it
is essential to put foods in closed dishes or wrap
them in cellophane, aluminium foil, grease-proof paper or
cling film before placing them into the refrigerator. This
way foods will keep their moisture e.g. vegetables will not
dry out after some days.

Some useful information and advice

The variable shelves are worth paying attention to,
which increases the usefulness of the fresh food
compartment considerably. Rearranging the shelves is also
possible when the door is open at an angle of 90°.
The inside configuration of the door makes rearranging the
door shelves as required possible.

Hints and ideas

In this chapter practical hints and ideas are given about
how to use the appliance to reach maximum energy saving
and there is environmental information about the appliance
as well.

How to save energy

The colder the ambient temperature of the appliance is
the less energy it uses.
Avoid putting the appliance in a sunny place and near
anything that gives off heat.
Be sure that the condenser and the compressor are
well ventilated. Do not cover the sections where
ventilation is.
Wrap products in tightly closing dishes or cling film to
avoid building up unnecessary frost.
Do not leave the door open longer than necessary and
avoid unnecessary openings.
Put foods into the appliance only in a closed dish.
Put warm foods into the appliance only when they are
at room temperature.
Keep the condenser clean at the back of the
appliance.
42

The appliance and environment

This appliance does not contain gasses which could
damage the ozone layer, in either its refrigerant circuit or
insulation materials. The appliance shall not be discarded
together with the urban refuse and rubbish. Avoid
damaging the cooling unit, especially at the rear near the
heat exchanger. Information on your local disposal sites
may be obtained from your municipal authorities.
The materials used on this appliance marked with the
sympol are recyclable.

Maintenance

Defrosting

Bleeding part of the moisture of cooling chamber in form of
frost and ice goes with the operation of the refrigerator.
Thick frost and ice has an insulating effect, so it reduces
cooling efficiency as the temperature increases and it
needs more energy.
At this type of appliance defrosting cooling compartment is
automatic without any external intervention.
The thermostatic control interrupts the operation of
compressor at regular intervals for more or less time -
during this cooling is interrupted - temperature of the
cooling compartment increases and defrosting occurs.
After defrosting the thermostatic control restarts operation
of the system.
Melting water flows through defrost water outlet into the
evaporative tray maintained on the top of compressor and
evaporates due to warmth of it.
Check and clean the outlet of melting water
coming during defrosting regularly. If it is
clogged the melting water gathered can cause earlier
failure as it can go to the insulating of the appliance.
Clean the melting water outlet with the supplied pipe
scraper that can be seen in the figure. The pipe scraper
has to be stored in the outlet.