Instructions For The Installer; Technical Data; Installing The Appliance; Transportation, Unpacking - Zanussi zrt 15 jc Gebrauchsanleitung

GB
Problem
The appliance does not
cool sufficiently
The appliance cools too
hard
The appliance does not
cool at all
The appliance is noisy
Inasmuch as the advice does not lead to result, call the nearest brand-mark service.

Technical data

Model/Type
Gross capacity (l)
Net capacity (l)
Width (mm)
Height (mm)
Depth (mm)
Energy consumption (kWh/24h)
(kWh/year)
Energy class, according to EU
standards
Star rating of frozen food
compartment
Freezing capacity (kg/24h)
Rising time (h)
Rated power (W)
Weight (kg)

Installing the appliance

Transportation, unpacking

It is recommended to deliver the appliance in original
packaging, in vertical position considering the protective
warning on packaging.
After each transportation the appliance must not be
switched on for approx. 2 hours.
Unpack the appliance and check if there are damages on
it. Report possible damages immediately to the place you
bought it. In that case retain packaging.

Cleaning

Remove every adhesive tape, which ensure the parts not
to move in the appliance.
Wash the inside of the appliance using lukewarm water
and mild detergent. Use soft cloth.
After cleaning wipe out the inside of the appliance.
46
Possible cause
Thermostatic control is set too low.
Too many foods to be cooled were put in.
Very warm foods were put in.
Door is not shut properly.
There is no inside cool air circulation.
The thermostatic control is set too high.
Plug is not connected to the mains socket
properly.
There is no voltage in the mains socket.
Thermostatic control is in „0" position.
The appliance is not supported properly.

Instructions for the Installer

ZRT 15 JC (TT 150-4S)
Frozen food comp.: 18
Fresh food comp.: 128
Frozen food comp.: 18
Fresh food comp.: 122
550
850
600
0,64
234
A
****
2
11
80
37
Set higher position.
Put fewer foods to be cooled.
Put foods max. at room temperature.
Check if the door is shut.
Provide inside cool air circulation.
Set lower position.
Check if the connection is proper.
Check if there is voltage.
Check setting of thermostatic control.
Check if the appliance stands stable (all the four
feet should be on the floor).

Placement

The ambient temperature has an effect on the energy
consumption and proper operation of the appliance.
When placing, take into consideration that it is practical
to operate the appliance between ambient temperature
limits according to the climate class that is given in the
chart below and can be found in the data label.
Class of climate
SN
N
ST
If the ambient temperature goes below the lower data the
temperature of the cooling compartment can go beyond
the prescribed temperature.
Solution
Ambient temperature
+10 ... +32 °C
+16 ... +32 °C
+18 ... + 38 °C