Change Of Door Opening Direction - Zanussi zrt 15 jc Gebrauchsanleitung

If the ambient temperature goes beyond the upper data
this means longer operating time of the compressor,
breakdown in the automatic defrosting increasing
temperature in the cooling compartment or increasing
energy consumption.
When placing the appliance ensure that it stands level.
This can be achieved by two adjustable feet (1) at the
bottom in front. 1-1 piece of distance washer (2) are
accessories of the adjustable feet. If levelling the
appliance requires, these washers can be removed.
Do not stand the appliance on a sunny place or close to
a radiator or cooker.
If it is unavoidable because of furnishing and the
appliance has to be stood near a cooker take these
minimum distances into consideration:
In case of gas or electric cooker 3 cm must be left,
when it is less put a 0,5-1 cm non-flam insulation
between the two appliances.
In case of oil or coal-fired stove the distance must be
30 cms since they give off more heat.
The refrigerator is designed to operate when it is totally
pushed to the wall.
When placing the refrigerator keep minimal
distances recommended in figure.
A : placing it under a wall-cupboard
B : placing it freely

Change of door opening direction

Should the setting-up place or handling demand it, door-
opening direction can be refitted from right-handed to
left-handed.
Following operations are to be done on the basis of
figures and explanations:
2
Pull out the plug from the mains socket.
Tilt back the appliance carefully being careful so that
1
the compressor can not touch the floor. It is
recommended to ask another person for help, who
can keep the appliance at this position safely.
Unscrew the adjustable feet situated on both sides (2
pieces), in addition the screws fixing the lower door
holders (3 pieces) respectively the screw on the
other side.
Put over the pin in the lower door holding plate in the
direction of the arrow.
Fix the plate on the other side leaving the position of
the door unchanged.
Then screw in the one screw in the place set free on
the other side as well as the adjustable feet (2
pieces) and set up the box.
For refitting the upper door holder take out the
screws (2 pieces) fixing the plastic top on the back of
the box.
Push back the top and lift it from the fixing elements.
Unscrew the screws fixing the upper door holder (2
pieces).
GB
47