Connection Of The High Vacuum Flange - Agilent Technologies TwisTorr304 FS X3500-64000 Bedienungshandbuch

17 Technical Information

Connection of the High Vacuum Flange

7
8
9
10 Plug the line cord and connect the pump cable to the pump;
11 Connect the mating connector with the jumper on the interlock
Figure 53

Connection of the High Vacuum Flange

In the case the rotor is suddenly blocked, the torque arising from the
system and the high vacuum flange must be absorbed. Only the
components listed in the following can be used to fasten the pump to
the high vacuum flange.
294/309
Rotate the bracket until the controller is on the chosen position;
Tighten the screws properly;
Turn the pump again;
signal to start the pump.
Mounting 2
TwisTorr 304 FS User Manual / 87-901-027-01(A)