Storage; Disposal; Troubleshooting - Chicago Pneumatic CP 4123 Serie Sicherheitsvorschriften Und Bedienungsanleitung

Safety and Operating instructions

Storage

Make sure that the machine is properly cleaned

before storage.
Pour approximately 2 oz. (5 cl) of oil directly

into the air inlet nipple, connect the machine to
the compressed air supply and run it for a few
seconds.
Always store the machine in a dry place.


Disposal

A used machine must be treated and deposed of
in such a way that the greatest possible portion
of the material can be recycled and any negative
influence on the environment is kept as low as
possible.

Troubleshooting

If the pneumatic hammer does not start, has
low power or uneven performance, check the
following points.
Check that the inserted tool being used has the

correct shank dimension.
Check that the pneumatic hammer is receiving

the correct amount of lubricant. Too much
lubrication can cause starting problems, low
power or uneven performance.
Check that the compressed air system supplies

the machine with sufficient air pressure to
provide full power.
Check that the dimension and length

of the air hose is in accordance with the
recommendations. See "Installation".
If there is a risk of freezing, check that the

machine's exhaust ports are not blocked.
If the machine function is still not satisfactory

after this procedure, contact an authorized
service workshop.
16
CP 4123, CP 4125
9800 0606 90