Protective Equipment; Service And Maintenance; Inserted Tools - Chicago Pneumatic CP 4123 Serie Sicherheitsvorschriften Und Bedienungsanleitung

Safety and Operating instructions

Protective equipment

Always use approved protective equipment.
Operators and all other persons in the working
area must wear protective equipment, including at
a minimum:
Protective helmet

Hearing protection

Impact resistant eye protection with side

protection
Respiratory protection when appropriate

Protective gloves

Protective boots


Service and maintenance

Regular maintenance is a prerequisite for keeping
the machine safe and effective. Carefully follow the
operating instructions.
Before undertaking any maintenance or changing
the inserted tool on pneumatic machines, always
switch off the air supply and bleed the machine
by depressing the start and stop device. Then
disconnect the air hose from the machine.
use only authorized parts. any damage

or malfunction caused by unauthorized
parts will not be covered by Warranty or
Product liability.
Change damaged parts immediately.

Replace damaged and worn components in

good time.
For major service to the machine, contact your

nearest authorized workshop.
When cleaning mechanical parts with solvents,

make sure to comply with current health and
safety regulations and that there is satisfactory
ventilation.
10

inserted tools

Keep the tools clean and in good condition.

Regulary check the inserted tools, make sure
that they are sharp and not worn out.
Note! The machine can be destroyed if you use
incorrect inserted tools.
CP 4123, CP 4125
9800 0606 90