Tips And Tricks; Maintenance And Cleaning; Maintenance; Cleaning - Parkside PFBS 10.8 A1 Originalbetriebsanleitung

Function
Milling
Engraving
Polishing, derusting
CAUTION!
Use only the lightest
contact pressure of
the tool on the work-
piece.

Cleaning

Grinding
Cutting and sawing
Be sure not to exceed the maximum diameter of
composite abrasive wheels and grinding cones
and cylinders with 55 mm thread insert, and
the 80 mm maximum diameter of sandpaper
grinding accessories.
Note: The max. permissible mandrel length is
33 mm.
Store accessories inside the original box or oth-
erwise protect the accessories from damage.
Store accessories dry and away from aggres-
sive media.

Tips and tricks

Applying excessive pressure can cause the in-
stalled tool to break and / or damage the work
piece. Optimal results can be achieved by ap-
plying the tool to the work piece at a steady
speed range and little pressure.
Hold the device with both hands whilst cutting.
Please note the data and information in the
Accessory Application
Milling bits Various tasks, e.g. hollowing out, gouging,
shaping, grooving or slotting
20
Engraving Making marks, craft projects
bits (see Fig. D)
21
Metal brush Derusting
16
Polishing Working on various metals and plastics, in
wheel particular noble metals like gold or silver
14
(see Fig. F)
Plastic brush E.g. cleaning complex plastic housings or
the area around a door lock
19
Grinding Grinding work on stone, wood; fine work
wheels on hard materials such as ceramic or alloyed
15
steel (see Fig. G)
Grinding bits
22
Cutting Cutting metal, plastic or wood
discs
17
Operation / Maintenance and cleaning
chart to prevent the spindle end touching the
perforated plate of the grinding tool.

Maintenance and cleaning

Q

Maintenance

Q
B efore and after a prolonged period of non-use
fully charge the battery pack
When storing a lithium-ion battery for extended
periods, regularly check the charge. The optimal
charge is between 50 % and 80 %. The optimal
storage climate is cooling and dry.
Cleaning
Q
C lean all the dirt off the drill / grinder. Use a dry
cloth for cleaning.
Projection
(min–max) mm
18–25
18–25
9–15
12–18
9–15
12–18
10
12–18
.
4
GB/MT 57