Safescan 2200 serie Handbuch Seite 7

ENGLISH | DEUTSCH | ČESKY | MAGYAR | БЪЛГАРСКИ | POLSKI | SLOVENČINA
E3. IR detection
Using this detection system, an alarm will sound and the [CHECK] screen will blink 'E3' if counterfeit or folded notes
appear.
5.2 Adjusting the sensitivity of the counterfeit detection
The Safescan 2200 series are equipped with adjustable sensors. This makes it possible to fine-tune the sensors
sensitivity to make the machine ready for every currency or banknote conditions.
Note: fine tuning the sensitivity is only needed when false counterfeit alarms occur. Before changing the sensitivity
levels, please first check chapter 7.0.
5.2.1 Adjusting the UV sensitivity
Press and hold the [UV] button until the [CHECK] screen will display "Axx", which means that the UV system is ready
for adjustment. You can now increase or reduce the sensitivity by pressing the [+] or [-] button. Press the [START]
button to confirm the adjustment made.
5.2.2. Adjusting the MG sensitivity (only available for 2250 model)
Press and hold the [MG] button until the secondary LCD screen will display "Bxx", which means that the MG system
is ready for adjustment. You can now increase or reduce the sensitivity by pressing the [+] or [-] button. Press the
[START] button to confirm the adjustment made.
5.2.3 How to adjust the IR sensitivity
Press and hold the [ADD] button until the secondary LCD screen will display "Cxx", which means that the IR system
is ready for adjustment. You can now increase or reduce the sensitivity by pressing the [+] or [-] button. Press the
[START] button to confirm the adjustment made.
Note: it is possible to pre-set the machine to add suspect notes to the count results.
To switch between the 2 options: Press and hold the [-] button until the [COUNT] screen displays: U00 or U01.
Press the [START] button to confirm your selection.
U00= No adding of suspected banknotes to the count total
U01= Add suspected notes to the count total
5.3 Adjusting the sensitivity of the Size detection
Press and hold the [BAT] button until the [COUNT] screen displays [dXX]. You can now increase or reduce
the sensitivity by pressing the [+] or [-] button. Press the [START] button to confirm the adjustment made.
6.0 RETURN TO THE FACTORY DEFAULT SETTINGS
Press and hold the [+] button until you hear a 'beep' indicating the settings are restored. The machine is now
returned to the default settings.
7.0 ERROR MESSAGES AND SOLUTIONS
7.1 Messages displayed on the [CHECK] screen
E1. UV detection error
1. Remove the banknote from the stacker and press [START] to continue your count.
2. Try to count the suspected banknote again. Ensure that the unit is removed from any strong light source
3. If the machine gives an alarm signal when it should not, lower the sensitivity level
(for details see chapter 5.2.1).
4. If step 3 does not solve the problem it can be possible the UV sensors needs to be cleaned from dust
(for details see chapter 8.3).