Cleaning And Maintenance; Cleaning; Maintenance - ULTIMATE SPEED UOP 12 C1 Originalbetriebsanleitung

4 . Push the drain hose (ø 12 mm)
drain hose connector 6 .
5 . Secure both hoses 9 ,
hose clamps . Make sure the hose clamps
10
are fitting tightly on the hose .
6 . Pay attention to the pumping direction
on the appliance .
m
Make sure that the hoses 9 ,
straightened to avoid damage.
˜ Operation
1 . Start the vehicle and run it for 5-10 minutes
to warm up the oil (60 °C is the maximum oil
temperature) . This reduces viscosity of the oil
and enables to pump it out more efficiently .
m
Do not pump the oil when the car
engine is running.
2 . Gently insert the suction hose (ø 6 mm) 9
into the bottom of the oil pan . (e .g . by the oil
level test opening) .
3 . Insert the drain hose (ø 12 mm)
container (e .g . oil collecting tray) .
4 . Set the on/off switch
position .
5 . Connect the positive pole clamp (red)
the positive pole (+) of the vehicle battery .
6 . Connect the negative pole clamp (black)
to the negative pole (‒) of the vehicle
battery .
7 . Turning on: Set the on/off switch
position . The pumping begins after a short
suction period .
8 . Turning off: Set the on/off switch
"O" . Turn the appliance off as soon as oil
extraction is over or after 30 minutes of
continuous operation .
12 GB/IE/NI
onto the
11
with the supplied
11
are
11
into a
11
to "O" (off)
1
to
4
5
to "I"
1
to
1
9 . After each use, pump through some fresh oil
to clean the appliance .
10 . Disconnect both clamps
vehicle battery .
m
To prevent damage let the appliance
cool for at least 10 minutes after
every 30 minutes of continuous
operation.
11 . Change the oil filter and refill with new oil
according to the vehicle instructions .
12 . Used oil needs to be disposed of in a way
according to "Disposal" .
˜ Cleaning and maintenance
m
Warning! During cleaning or operation
do not immerse the electrical parts of the
appliance in water or other liquids . Never
hold the appliance under running water .

Cleaning

1 . After each use, pump through some fresh oil
to clean the appliance .
2 . Clean both clamps
cloth after each use . Make sure there is no
adhering battery fluid left on the appliance .
3 . Keep the casing
2
Do not use abrasive, aggressive or chemical
cleaning agents to clean the surface of the
appliance .
4 . In case of oil spillage, clean it with a soft
cloth or a paper towel .

Maintenance

Check the hose clamps
Before each use check the appliance and all
its accessories for any visible damage .
Apart from the occasional cleaning, the
appliance is maintenance-free .
, from the
4 5
, with a dry
4 5
and accessories clean .
for tight fit .
10