Werbung
GB
Safety Instructions
Before starting the mixer
Ensure engine oil is fi lled to correct level before operating mixer. Note: The engine must be
lifted to the horizontal position when fi lling and checking oil.
Check that all guards are in position and correctly fi tted.
DO NOT wear loose clothing or jewellery that may become entangled in the workings of this
machine.
Suitable clothing as follows should meet relevant EEC/local safety standards: overalls, work
boots, goggles, face mask, gloves and ear defenders etc.
DO NOT tip mixer onto the drum mouth when motor is running.
Ensure that any trailing cable is protected against damage and not liable to be tripped over or
trapped underneath the mixer.
We recommend the use of an Residual Current Device on 230v electrics.
Remove all packaging material before operating.
When operating the mixer
Keep unauthorised persons away from mixing drum.
Keep area around the mixer clear of obstructions which could cause persons to fall onto
moving parts.
Always ensure mixer is on level ground before mixing.
DO become familiar with the controls before operating this machine.
DO ensure that all guards are fi tted in the correct position.
DO ensure plenty of ventilation when running diesel/petrol engines in a confi ned area.
DO replace any worn/damaged warning decals.
DO ensure the drum is rotating while emptying the mixer.
DO always switch off and remove the plug from the socket if leaving the machine unattended.
DO NOT use as a wheel barrow. Disconnect from power supply before moving.
BEWARE of the Danger Zones & Hot Zones.
BE AWARE of exhaust venting directions.
Emergency Stop
If you have to turn off the mixer in a emergency you must: Electric: either turn off at switch or at the mains,
Petrol: turn the engine switch off, see engine manual.
Fire Fighting
If your mixer catches fi re, turn off the electric supply. Using a dry powder or C02 fi re extinguisher put out
the fi re. If the fi re can not be put out, keep away and call the fi re brigade. If you are in any doubt about the
safety condition of your machine, please contact your Belle authorized Service Dealer.
Warning - Important Should the socket outlets in your home not be suitable for the plug supplied with your product, the plug
must be removed (cut-off if it is a moulded plug and disposed of) and an appropriate plug fi tted. Follow wiring instructions
carefully. Do not connect either core to the earth pin, as this is a Class II Isolated Product. BLUE = NEUTRAL BROWN = LIVE
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the
terminals in your plug, proceed as follows: The wire which is coloured Blue must be connected to the terminal which is is
marked with the letter N or coloured Black. The wire which is coloured Brown must be connected to the terminal which is is
marked with the letter L or coloured Red.
4
49
s
Werbung
Kapitel
