Clearing Paired Devices; Connecting The Headphones Through Audio Cable - Silvercrest SBKP 1 A1 Bedienungs- Und Sicherheitshinweise

Now connect to the second communication device via Bluetooth
headphones. Please refer to the notes in the instructions for your communi-
cation device. Select the entry "SBKP 1 A1" from the list of devices detected
by your computer or mobile. The second communication device is connected.
Briefly press button
cation device is connected again. Now, both communication devices are
connected to the headphones simultaneously.

Clearing paired devices

In paired mode (the LED will briefly flash blue twice every 3 seconds),
press and hold
The headphones is now in pairing mode. The LED
Simultaneously pressing and holding
approx. 2 seconds and two beeps sound.
The memory in the headphones is cleared and it will not auto-connected to
the previous paired communication device.

Connecting the headphones through audio cable

Insert the 3.5 mm plug at one end of audio cable
Insert the 3.5 mm plug at other end of audio cable
your playback device.
The headphone will be auto power off if it has been power on before and
the LED light off.
2
Start a playlist on your playback device. You can only adjust the music
volume on the playback device.
and acoustic signal sounds. The first communi-
6
button for 2 seconds and acoustic signal sounds.
6
flashes red and blue.
2
button and button
6
to 3.5 mm socket
14
to 3.5 mm socket of
14
with the
®
for
4
.
10
GB/MT 65