Herunterladen Inhalt Inhalt Diese Seite drucken

Radio Reception - Sony CDX-DAB500U Bedienungsanleitung

Dab/fm/mw/lw digital radio cd player
Vorschau ausblenden Andere Handbücher für CDX-DAB500U:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

No beep sound.
 The beep sound is canceled (page 21).
 An optional power amplifier is connected and
you are not using the built-in amplifier.
The contents of the memory have been
erased.
 The power supply lead or battery has been
disconnected or not connected properly.
 The unit is reset.
– Store again into the memory.
Stored stations and correct time are erased.
The fuse has blown.
Makes noise when the position of the
ignition is switched.
 The leads are not matched correctly with the
car's accessory power connector.
During playback or reception,
demonstration mode starts.
 If no operation is performed for 5 minutes
with "DEMO-ON" set, demonstration mode
starts.
– Set "DEMO-OFF" (page 5).
The display disappears from/does not
appear in the display window.
 The dimmer is set to "DIM-ON" (page 22).
 The display disappears if you press and hold
.
– Press  on the unit until the
display appears.
 The connectors are dirty (page 25).
The Auto Off function does not operate.
 The unit is turned on. The Auto Off function
activates after turning off the unit.
– Turn off the unit.
The operation buttons do not function.
The disc will not eject.
 Press  and
more than 2 seconds.
The contents stored on the memory are erased.
For your safety, do not perform the reset
operation while you are driving
(BACK)/ for

Radio reception

The stations cannot be received.
The sound is hampered by noises.
 The connection is not correct.
– Check the connection of the car antenna
(aerial).
– If the auto antenna (aerial) will not go up,
check the connection of the power antenna
(aerial) control lead.
 See "NO SERVICE" (page 29) for details when
the DAB signal cannot be received.
Preset tuning is not possible.
 Store the correct frequency in the memory.
 The broadcast signal is too weak.
Automatic tuning is not possible.
 The broadcast signal is too weak.
– Perform manual tuning.
RDS
The SEEK starts after a few seconds of
listening.
 The station is non-TP or has weak signal.
– Deactivate TA (page 10).
No traffic announcements.
 Activate TA (page 10).
 The station does not broadcast any traffic
announcements despite being TP.
– Tune in another station.
PTY displays "- - - - - - - -."
 The current station is not an RDS station.
 RDS data has not been received.
 The station does not specify the program type.
Program service name flashes.
 There is no alternative frequency for the
current station.
– Press  +/– while the program service
name is flashing. "PI SEEK" appears and the
unit starts searching for another frequency
with the same PI (Program Identification)
data.
27

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Cdx-dab500a

Inhaltsverzeichnis