Package Contents; Intended Use - DeWalt XR DCF610 Bersetzt Von Den Originalanweisungen

Lithium-ion cells and batteries have been tested to section 38.3
of the UN Recommendations on the Transport of Dangerous
Goods Manual of Tests and Criteria.
In most instances, shipping a D
excepted from being classified as a fully regulated Class 9
Hazardous Material. In general, only shipments containing a
lithium-ion battery with an energy rating greater than 100 Watt
Hours (Wh) will require being shipped as fully regulated Class 9.
All lithium-ion batteries have the Watt Hour rating marked on
the pack. Furthermore, due to regulation complexities, D
does not recommend air shipping lithium-ion battery packs
alone regardless of Watt Hour rating. Shipments of tools with
batteries (combo kits) can be air shipped as excepted if the Watt
Hour rating of the battery pack is no greater than 100 Whr.
Regardless of whether a shipment is considered excepted
or fully regulated, it is the shipper's responsibility to consult
the latest regulations for packaging, labeling/marking and
documentation requirements.
The information provided in this section of the manual is
provided in good faith and believed to be accurate at the time
the document was created. However, no warranty, expressed or
implied, is given. It is the buyer's responsibility to ensure that its
activities comply with the applicable regulations.
Battery Pack
Battery Type
The DCF610 operates on a 10.8 volt battery pack.
These battery packs may be used: DCB123, DCB125, DCB127.
Refer to Technical Data for more information.
Storage Recommendations
1. The best storage place is one that is cool and dry away
from direct sunlight and excess heat or cold. For optimum
battery performance and life, store battery packs at room
temperature when not in use.
2. For long storage, it is recommended to store a fully charged
battery pack in a cool, dry place out of the charger for
optimal results.
nOtE: Battery packs should not be stored completely depleted
of charge. The battery pack will need to be recharged before
use.
Labels on Charger and Battery Pack
In addition to the pictographs used in this manual, the labels
on the charger and the battery pack may show the following
pictographs:
Read instruction manual before use.
See Technical Data for charging time.
Do not probe with conductive objects.
WALT battery pack will be
e
WALT
e
Do not charge damaged battery packs.
Do not expose to water.
Have defective cords replaced immediately.
Charge only between 4 ˚C and 40 ˚C.
Only for indoor use.
Discard the battery pack with due care for the
environment.
Charge D WALT battery packs only with designated
e
D WALT chargers. Charging battery packs other
e
than the designated D
D WALT charger may make them burst or lead to
e
other dangerous situations.
Do not incinerate the battery pack.

Package Contents

The package contains:
1 Screwdriver
1 Charger
2 Batteries
1 Screwdriver bit
1 Kitbox
1 Instruction manual
• Check for damage to the tool, parts or accessories which may
have occurred during transport.
• Take the time to thoroughly read and understand this manual
prior to operation.
Description (Fig. A, D)

WARNING: Never modify the power tool or any part of it.
Damage or personal injury could result.
Variable speed trigger switch
1
Forward/reverse button
2
Torque adjustment collar
3
Quick-release chuck
4
Main handle
5
Battery pack
6
Battery release button
7
Worklights
8
Bit groove (Fig. D)
9
Quick-release chuck collar (Fig. D)
10

Intended Use

This screwdriver is designed for professional screwdriving
applications..
EngLIsh
WALT batteries with a
e
27