Indel B FM7 BACK Bedienungsanleitung Seite 31

by a dedicated electric line and have a dedicated circuit breaker. In situations of voltage
peaks on the power supply mains, due to direct or indirect lightning, the device can get
blocked. Try to reset the device and, if the block persists, contact the authorized After-Sales
Service Centre.
• Do not use the device near or stacked over other equipment. Should this condition not be
possible, check the correct operation of the device itself, in the configuration where it is
being used.
TR A N S P O R TATI O N A N D D I S PL AC E M E NT
The device must be transported and moved only while in vertical position, respecting
the indications on its packaging. This precaution is necessary to avoid the circulation of the
compressor oil, which could damage the valves and coils, and create starting problems to the
electric motor. The Manufacturer shall not be liable for problems due to a transportation made
in a way different from what stated here.
I N S TA LLI N G TH E R E FR I G E R ATO R I N A V E H I C LE
Attention: Before fastening the device, make sure that the chosen position is suitable
to contain it, and that the correct ventilation is assured.
To fasten the device, having it inserted in a compartment inside a vehicle, fasten the stainless
steel frame (flange) to the sides of the compartment using eight self-threading screws, with 5.5
mm diameter and flat countersunk head, as shown in figure.
Attention: After installation of the device, before putting it in operation, check its
stability and its complete fastening to the vehicle.
29