Spare Parts; Technical Information - THERMOBILE Bio Energy 1 Bedienungsanleitung

English
Fault
The flame goes out
directly after ignition.
The fuel pump does
not run and the con-
trol light is off, while
the heater is pre-
heated and the
switch is switched to
"1" or "2".
The flame is extin-
guished while the
fuel pump is still run-
ning.
The heater makes a
humming sound.
There is soot forma-
tion in the combus-
tion chamber and in
the flue.
There is unburnt fuel
on the burner dish.
Record the maintenance details in table A in
the appendix of this manual.
7

SPARE PARTS

Before use we advise you to have spare parts
in store, see table B in the appendix of this
manual.
26
Cause
13 The maximum thermo-
stat is not installed prop-
erly or defective.
14 The overflow protection
is filled with vegetable
oil or biodiesel
15 There is too much vege-
table oil or biodiesel at
starting up.
16 There is too much vege-
table oil or biodiesel at
starting up.
40.020.944 - rev. 05 - 2015
Solution
Reset the thermostat, see fig.
3(Q).
Replace the thermostat, see
fig. 3(Q).
Clean the overflow protection
dish, the burner dish and the
floor of the vaporiser.
See faults: 3, 6, and 14.
See faults: 2, 5, 7, 9, 10 and
12.
Reduce the amount of vege-
table oil or biodiesel.
See faults: 10, 11, and 12.
See faults: 8, 9, 10, 11 and
12.
Reduce the amount of vege-
table oil or biodiesel.
See faults: 8, 9, 10, 11 and
12.
8

TECHNICAL INFORMATION

• See for technical specifications table C in
the appendix of this booklet.
Action
User
Dealer
User
User
Bio Energy series