Clas Ohlson FD-40KI Bedienungsanleitung Seite 5

Assembly
Attaching the base
1. Attach the pedestal extension tube to the base
using Screw B and the base washer.
Fan head assembly
1. Undo the locking ring and
extend the pedestal tube.
Tighten the locking ring.
2. Undo Screw A and place
the fan head onto the pede-
stal tube. Tighten Screw A.
3. Undo the locking ring and
adjust the fan to the desired
height. Tighten the locking
ring securely.
Fitting the fan blade
1. Remove the grille nut.
2. Thread the rear grille over the motor shaft and align it on the locating pins.
3. Fix the rear grill in position by screwing the grille nut on tightly.
4. Thread the fan blade onto the motor shaft. Tighten the nut (3) securely.
Note: The nut has a left-hand thread.
5. Clip the front grille into the grille ring.
Pedestal extension
tube
Locking ring
Grille nut Locating pins
5
Screw A