Panasonic AW-E860L Bedienungsanleitung Seite 39

G Electronic Shutter Synchro Scan Setting
[Synchro Scan: 50.24Hz to 15.63kHz]
This setting is possible only when Electronic Shutter
setting is at S/Scan.
Horizontal bar noise can be reduced by synchro-scan
adjustment in shooting workstation scenes, for example.
For luminance settings at each shutter speed and
synchro-scan shutter speed, refer to the table below.
Shutter Speed Synchro-scan
OFF —
1/120 120.2 Hz
1/250 250.0 Hz
1/500 492.2 Hz
1/1000 984.4 Hz
1/2000 1.969 kHz
1/4000 3.938 kHz
1/10000 7.875 kHz
H CCD Read Out Mode Setting
[V Resolution: Normal, Fine]
Normal: Normal image. (CCD storage will be by field
storage.)
Fine: Vertical resolution increases. (Vertical resolution
is raised without increasing residual images by
frame storage and Electronic shutter.)
Normal is recommended for general use
because sensitivity will decrease at the Fine
setting.
Required luminance ratio
1
2
4
8
16
32
64
160
- 38 (E) -
I PC Control Access Speed Setting [Baud Rate:
1200bps, 2400bps, 4800bps, 9600bps]
Select a communication speed in controlling the camera
from the computer.
J Component Output Setting
[Signal Select: RGB, Y/Pr/Pb, Y/C]
This enables RGB, Y/Pr/Pb or Y/C to be selected as the
component signals which are to be output from the I/F
REMOTE connector.
K Aspect Ratio Selection [Aspect Ratio: 16:9, 4:3]
Aspect ratio can be selected from 16:9 or 4:3.
L Fan Setting [Fan SW: OFF, Auto]
OFF: Select this setting to stop the fan when its
operating sound is found to be bothersome in a
studio or other such environment.
Auto: The temperature is detected automatically, and
the fan starts operating when the temperature
exceeds approx. 35°C.
Under normal circumstances, the "Auto" setting is
used.