Safety Regulations; Precautions Before Starting - Atlas Copco TEX 14P Bedienungsanleitung

English

Safety regulations

These instructions contain important sections dealing with safety.
Special attention must be paid to all framed safety text that begins with a warning symbol (triangle) followed
by a signal word, as shown below
!
WARNING
!
CAUTION
Also observe the following general safety rules:
• Before starting the machine, read through these instructions carefully.
• Also read through the red safety instructions before putting the machine to use.
• For reasons of product safety, the machine must not be modified.
• Use approved personal protective equipment.
• Use Atlas Copco Genuine Parts only.
• Replace damaged or worn plates.
Main parts of the machine
1. Air inlet
2. Oil filler plug
3. Handle
4. Silencer, Type PS, PE
5. Air valve/trigger
6. Bolt (350 Nm)
7. Front head
8. Tool retainer
9. Machine ID plate (always state machine type
and serial No. when ordering spare parts).

Precautions before starting

!
WARNING
To maintain correct function of the machine,
always replace worn or damaged parts.
!
CAUTION
Before removing the oil plug, switch off the
air supply and vent the machine, otherwise
oil may squirt into your face.
• The machine is equipped with a built-in lubricator.
Lubricating oil is essential for good machine func-
tion and service life.
• Use synthetic air-tool oil type AIR-OIL, or mineral
base oil.
3
denotes a hazard or hazardous procedure which CAN lead to
serious or life-threatening injuries if the warning is not
observed.
denotes a risk or risky procedure which CAN lead to personal
injury or damage to equipment if the caution is not observed.
• Make it a rule to fill the oil container with the re-
commended oil daily.
Lubricant
Synthetic oil
AIR-OIL
Mineral
base oil
N.B. When checking the oil level or filling with oil, the
machine must be in the vertical position.
• First clean around the oil filler plug, then screw
out the plug.
• Fill with the recommended oil up to the "lowest"
thread, then fit back and tighten the plug.
• Check that the compressed-air hose and fittings
are not damaged, and that all compressed-air
connections are properly attached.
Choose the correct size and length of hose.
• Make sure that you have the correct working
pressure max. 7 bar (e).
• Before connecting the compressed-air hose to
the machine, blow through it with compressed air
to remove any foreign matter.
• Choose the correct tool and shank size. When in-
serting certain tools, you must align the hexago-
nal shank so that the tool has the correct working
angle.
• Open the tool retainer. Insert the tool. Close the
retainer.
Temperature
Viscosity grade
range °C
-30 to +50 ISO VG 46 - 100
+15 to +35 ISO VG 46 - 100
-20 to +15 ISO VG 32 - 46
English