Werbung
unit all the way into the openings in the fork.
16 • Fasten the dashboard with the screws.
17 • Loosen the screw on the battery compartment
cover, near the instrument panel on the
dashboard.
18 • Pull out the battery holder and insert two 1.5V
AA batteries (not supplied with the
motorcycle), taking care to place the positive
and negative poles correctly. Close the battery
compartment cover and tighten the screw.
19 • Mount the two mirrors as shown in the figure,
turning them to the correct position.
20 • Using the supplied tool, loosen the nuts on
both sides of the rear wheel axle.
21 • Remove the spacers from both sides.
22 • Insert the training wheels and fasten with a
washer and nut on each side. Tighten the
training wheels. Attention: when removing the
training wheels, remember to put the spacers
back on.
23 • Open the seat fastener and pull the seat up.
Attention: always close the seat after working
inside the battery compartment.
24 • Connect the two plugs. Close the seat. The
vehicle is ready for use.
VEHICLE FEATURES AND USE
25 • ELECTRONIC MODULE: To switch on the
electronic module, turn the key clockwise. To
blow the horn, press button A (top button) on
the dashboard. To turn the headlight on, press
button B (lower button).
We recommend turning the key off when not using
the vehicle to avoid draining the battery.
26 • ACCELERATOR HANDLE: Turn the handle
downwards to start the vehicle.
27 • BRAKE LEVER: Press the brake lever to stop the
vehicle.
28 • HIGH SPEED: Loosen the screw-on fuel cap.
29 • Turn the switch towards the right to activate
the second speed. Close by screwing the cap
back on.
REPLACING LIGHT BULBS (2,5 volts)
30 • Use a screwdriver to pry the glass off the
headlight.
31 • Gently pull the bulb out of the socket. Unscrew
the burnt light bulb and replace it. Push the
bulb back into the headlight. Snap the glass
back onto the headlight.
32 • To replace the battery, loosen up the screws of
the tank and unfasten the hook of the saddle.
Then pull out the saddle.
33 • Loosen the screws on the battery clamp and
disconnect the plugs.
34 • Lift the tank, pull out the old battery and
replace it with the new one. Place the battery
holder back to its place and fasten it in position
with the 2 screws. Connect up the 2 plugs, then
close the tank by tightening the 2 screws.
Lower the saddle.
CHARGING THE BATTERY
ATTENTION: CHARGING THE BATTERIES OR
CARRYING OUT ANY OTHER KIND OF OPERATION
ON THE ELECTRICAL SYSTEM MUST BE DONE BY AN
ADULT ONLY. THE BATTERY CAN BE CHARGED
WITHOUT REMOVING IT FROM THE TOY.
35 • Disconnect vehicle plug A from battery plug B
by pressing on the sides.
36 • Plug the battery charger into an electrical
outlet, following the instructions that come
with the battery charger. Connect plug B to
plug C on the battery charger.
37 • When the battery is finished charging,
disconnect the battery charger from the
electrical outlet, then disconnect plug C from
plug B.
38 • Press plug B all the way into plug A. When
finished working on the vehicle, always
remember to close and lock the seat.
BATTERY MAINTENANCE AND SAFETY
Before riding, charge your batteries for 18 hours to
initiate them. Failure to do this will result in
permanent battery damage.
CAUTION
Rechargeable batteries are only to be charged
under adult supervision.
Never allow children to handle batteries.
CHARGE BATTERY
• Charge the batteries no longer than 24 hours,
following the instructions enclosed with the
battery charger.
• Charge the battery, as the vehicle shows low
power, in this way you will avoid damage to the
battery.
• If you don't use your vehicle for a long period of
time unplug the battery from the main wire
harness of the vehicle. Remember to charge the
battery at least every three months.
• Never charge the battery upside down.
• Do not forget batteries during charging! Check
them periodically.
• Never use a replacement recharger or batteries
unless they are approved by PEG PEREGO.
• Do not mix old and new batteries.
• Batteries are sealed and maintenance free.
• Battery polarity must be observed when
connecting battery to wiring.
WARNING
• BATTERIES CONTAIN TOXIC AND CORROSIVE
SUBSTANCES. DO NOT TAMPER WITH THEM.
• Batteries contain an acid-based electrolyte.
• Do not make direct contact between battery
terminals, as this can cause an explosion or fire.
• Charging produces explosive gases. Charge
batteries in a well ventilated area away from
sources of heat and flammable materials.
• Exhausted batteries are to be removed from the
vehicle.
• Do not place the batteries near clothing to avoid
damage.
IF A LEAK DEVELOPS
Shield your eyes. Avoid direct contact with the
electrolyte, protect your hands.
Place battery in a plastic bag and follow directions
listed below.
IF ELECTROLYTE COMES IN CONTAC WITH SKIN OR
CLOTHING
Flush with cool water for at least 15 minutes.
See a physician at once.
IF ELECTROLYTE IS INJESTED
Rinse your mouth and spit.
See a physician at once.
DISPOSAL OF BATTERIES
Help protect the environment!
Do not throw used batteries in your regular, house
hold trash.
Dispose of the old batteries in an approved
dumping station; contact your local environmental
protection agency office for further information.
CAUTION AA 1,5 VOLT BATTERY
The insertion of batteries must only be carried out
or supervised by adults. Do not let children play
with the batteries.
• The batteries should be replaced by an adult.
• Use only the type of battery specified by the
manufacturer.
• Respect the polarity +/-
• Do not allow the batteries to be in contact with
metal parts (risk of fire or explosion).
• Always remove the batteries if the toy is not in use
for a long period.
• Do not throw batteries on the fire.
• Never attempt to charge batteries that are not
rechargeable.
• Remove dead batteries from the toy.
• Dispose of dead batteries into containers
provided for the recycling of dead batteries.
VEHICLE MAINTENANCE AND SAFETY
This product conforms to EN 71 and conforms to EN
50088 safety standard for electric toys.
This vehicle is not intended for use on streets,
around traffic or parked cars.
MAINTENANCE AND CARE
• Regularly check the conditions of the vehicle,
particularly the electrical system, the plug
connections, the covering caps and the charger. In
case of fault, do not try to use the vehicle and the
charger. For repair use only original PEG PEREGO's
spare parts.
• PEG PEREGO assumes no liability if the electrical
system is tampered with.
• Do not leave vehicle or batteries near sources of
heat such as radiators, stoves, fireplaces, etc.
• Protect vehicle from water, rain, snow, etc. Do not
ride in loose sand or mud as these substances will
cause premature failure of switches, motors and
gears.
• When operating in overload conditions, such as
soft deep sand, mud or rough uneven terrain, the
overload circuit breaker will automatically
disconnect the power. After 10 or more
seconds,the circuit breaker will automatically
reset, howevere you must eliminate overload
conditions to resume normal driving.
• Periodically lubricate (with a light weight oil)
moving parts, such as wheel bearings, steering
linkages, where they rotate or touch one another.
• The vehicle's surface can be cleaned with a
dampcloth. Do not use abrasive cleaners. The
cleaning must be carried out by adults only.
• Never disassemble the vehicles mechanisms or
motors unless authorized by PEG PEREGO.
Conforms a EN 50088
Recargeable battery 12V 8Ah sealed lead-acid
battery.
Two 140W motors
SAFETY
WARNING! THE CAR MUST BE USED UNDER ADULT
SUPERVISION.
• Not suitable for children under the age of 36
months. The small pieces could be swallowed or
inhaled.maturation to operate this motorized
vehicle safely.
• Never use the vehicle on steep slopes or near
steps or stairs. This vehicle is not suitable for use
on public highways.
• Children should always wear shoes when riding in
or driving a ride-in/ride-on vehicle.
• Do not allow children to place their hands, feet or
any part of their body, clothing or other articles
near the moving parts while vehicle is in
operation.
• Do not allow the electrical components, motors,
wiring, switches of your motorized vehicle to
become wet and never wash it with a hose.
• Never use gasoline or other flammable
substances near the vehicle.
• The vehicle is constructed just for one child.
RULES FOR SAFE DRIVING
DON'T STOP THE FUN: always have freshly charged,
back-up batteries on hand.
For your child's safety: please read and follow all
instructions below before operating.
• ATTENTION:
Check the fastening studs to be sure they are
tight.
2nd SPEED
Initially we suggest using only the 1st speed and
the reverse gear. Before moving into 2nd speed be
sure that the child has become familiar with
operating the vehicle.
• 1ST SPEED slow speed (beginner drivers):
With both hands on the handlebars, press down
on the accelerator pedal; the vehicle goes forward
at 3,7 Km/h - 2,3 mph.
• 2ND SPEED fast speed (exsperienced drivers):
With both hands on the handlebars, press down
on the accelerator pedal; the vehicle goes forward
at 7,5 Km/h - 4,7 mph.
• BRAKE:
To stop decelerate by turning the knob upwards
and press the brake pedal.
Teach your child the proper use of this vehicle for a
safe and fun play time.
• Before starting be sure that the way is free from
people and objects.
• Drive with both hands on the handlebar and keep
your eyes on the road at all times.
• Stop in time to avoid accidents.
• Use the 2nd speed only after your child has the
maturity and the reflexes to operatye vehicle
safety.
• CAUTION! In first gear, the vehicle as a
differential effect like real cars: on smooth
terrain and with one child, the two wheels may
turn at different speeds, resulting in possible
sliding/deceleration.
• When operating in overload conditions, such
as soft deep sand, mud or rough uneven
terrain, the overload circuit breaker will
automatically disconnect the power. After 10
or more seconds,the circuit breaker will
automatically reset, howevere you must
eliminate overload conditions to resume
Werbung
