Eliminating Minor Faults Yourself - Siemens ki24fa60 Gebrauchsanleitung

Eliminating minor faults yourself

Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following
information.
Customer service will charge you for advice – even if the appliance is still under
guarantee!
Fault
Temperature differs
greatly from the set
value.
The light does not
work.
The frozen food is
frozen solid.
There is a thick layer
of frost in the freezer
compartment.
Bottom
of the refrigerator
compartment is wet.
Possible cause
The bulb is defective.
Light switch is
jammed.
The condensation
channel or drainage
hole are blocked.
Remedial action
In some cases it is adequate
to switch off the appliance
for 5 minutes.
If the temperature is too high wait
a few hours and check whether
the temperature has approached
the set value.
If the temperature is too low check
the temperature again the next day.
Replace bulb. Fig. 0/B
1. Switch the appliance off.
2. Pull out mains plug or switch off
fuse.
3. Slide cover forwards and remove.
4. Change the bulb.
(Replacement bulb:
220–240 V a.c., E14 bulb holder,
see defective bulb for wattage.)
Check whether it can be moved.
Fig. 0/A
Loosen frozen food with a blunt
object. Do not use a knife or pointed
object.
Defrosting the freezer compartment
(see chapter Defrosting). Always
ensure that the freezer compartment
door is closed properly.
Clean the condensation channel
and the drainage hole. See chapter
Cleaning the appliance. Fig. ,
en
39