Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
DMX-controlled operation
You can control the projectors individually via your DMX controller. Every DMX channel has a different
occupation with different features. The individual channels and their features are listed under Functions in
DMX mode.
The device has three DMX channel modes. The Control Board allows you to assign the DMX channel mode.
Addressing
The Control Board allows you to assign the DMX starting address, which is defined as the first channel from
which the device will respond to the controller.
If you set, for example, the address in the 4 channel mode to channel 5, the device will use the channel 5 to
8 for control.
Please, be sure that you don't have any overlapping channels in order to control each device correctly and
independently from any other fixture on the DMX-chain. If several devices are addressed similarly, they will
work synchronically.
Note:
After switching on, the device will automatically detect whether DMX 512 data is received or not. If there is
data received at the DMX-input, a star flashes in the display. If there is no data received, no star appears.
This situation can occur if:
- the XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
Functions in DMX mode
2 channel mode
Decimal Hexad. Percentage S/F
0 255 00 FF
0% 100%
Decimal Hexad. Percentage S/F
0 150 00 96
0% 59%
151 200 97 C8
59% 78%
201 205 C9 CD 79% 80%
206 255 CE FF
81% 100%
Control-channel 1 - Dimmer
F
Gradual adjustment of the dimmer intensity from 0 to 100 %
Control-channel 2 - Rotating gobo index, gobo rotation
F
Gobo indexing
F
Forwards gobo rotation with increasing speed
S
No rotation
F
Backwards gobo rotation with increasing speed
24/28
Feature
Feature
00125717.DOCX, Version 1.0
Werbung
Inhaltsverzeichnis
