Endress+Hauser FGQ61 Einbauanleitung

EA01142F/00/A2/02.18
71406723
2018-07-31
*71406723*
71406723
Overview
The manual applies to the following spare part sets.
Order number Original spare part set
71301298 Terminal box FQG66
71308587 Terminal box FQG61, FQG62
We recommend that the Installation Instructions are kept with the packaging at all times.
Designated use
The spare part set and the Installation Instruction are used to replace a faulty unit with a functioning unit of the same type. Use
genuine parts from Endress+Hauser only.
Only original spare part sets, intended by Endress+Hauser for the measuring device, must be used.
The verification has to be done via W@M Device Viewer; this procedure is explained below.
For some devices there is an overview of spare part sets inside the device. If the spare part set is listed there, the verification
is not required.
1. www.endress.com/deviceviewer
2.
Ser. No.: 12345
Authorized personnel
Authorization to carry out a repair depends on the approval of the measuring device. The table shows the respective group of
persons for each.
The person who carries out the repair is responsible for safety during the work, the quality of work completed and safety of
the device after repair.
Products
Installation Instructions
Terminal box
Source container FGQ61, FQG62, FQG66
Order code Description
3.
=
?
4.
Solutions
Use
Source container FQG66
Source container FGQ61, FQG62
1. www.endress.com/deviceviewer
2. Enter serial number (Ser. No.), search for product data and click
on "spare parts".
3. List of all spare parts sets for the device.
4. Determine the order number of the spare part set.

The spare part set can only be used if the order number of the
spare part set corresponds to the order number on the spare part
list.
Services