Connection Of Water Hose To The Jug - Beko GNE 60520 DX Bedienungsanleitung

Connection of Water Hose to
the Jug
(in some models)
To connect water to the refrigerator
from a jug, a pump is needed. Follow
the instructions below after connecting
one end of the water pipe coming
out of the pump to the refrigerator as
described on the previous page.
1. Finish the connection by pushing
the other end of the water pipe into
the water pipe inlet of the pump as
shown in the figure.
2. Put and fix the pump hose into the
jug as shown in the figure.
3. After completing the connection, plug
in and run the pump.
1a
1b
To provide an efficient operation of the
pump, wait for 2-3 minutes after
starting the pump.
C
You may refer to the user manual
of the pump while making the water
connection.
C
There is no need to use water filter in
case a jug is used.
C
Pump must be used when jug will be
used.
2
13
EN