Telescopic Handle; Start And Stop Of The Machine (When Connected To A Water Supply) - Berner BHPC 150-1 4-in-1 Lance Betriebsanleitung

5.3 Telescopic handle

5.4 Start and stop of the ma-
chine (when connected
to a water supply)
Original Instructions
The spray lance is affected
by a thrust during opera-
tion - therefore always hold it
fi rmly with both hands. IMPOR-
TANT: Point the nozzle at the
ground.
1. Check that the machine is in
upright position.
NOTE: Do not place the ma-
chine in tall grass!
2. Release the trigger lock.
3. Activate the trigger of the
spray handle and let the wa-
ter run until all air has es-
caped from the water hose.
4. Turn the start/stop switch (1)
to position "I".
5. Activate the trigger of the
spray handle.
Always adjust the distance and
thus the pressure of the nozzle
to the surface, which is to be
cleaned.
BHPC 150-1 4-in-1 Lance
The machine features a tele-
scopic handle. To raise or lower
the handle, press the button
(13) and move the handle up-
wards or downwards. When a
click is heard, the handle is in
right position.
Do not cover the machine
during operation.
Note: If the ma-
chine is left or
not used for 5
minutes, it must be switched off
on the start/stop switch "O" (1):
1. Turn the start/stop switch to
position "O".
2. Disconnect the electrical plug
from the socket.
3. Shut off the water supply and
activate the trigger to relieve
the machine of pressure.
4. Lock the spray handle.
When releasing the trigger of
the spray handle, the machine
automatically stops. The ma-
chine will start again when you
re-activate the spray handle.
DE
EN
FR
IT
ES
NL
DA
NO
SV
FI
PT
35