Berner BHPC 150-1 4-in-1 Lance Betriebsanleitung Seite 30

BHPC 150-1 4-in-1 Lance
Safety devices
DE
Locking device on spray handle:
EN
• The spray handle features a locking device. When the
FR
Thermal sensor:
IT
• A thermal sensor protects the motor against overload-
ES
NL
Pressure safety device:
DA
• An integrated hydraulic safety valve protects the
NO
During work
SV
FI
• It is not allowed to clean asbestos-containing surfaces
PT
• Risk of explosion – Do not spray fl ammable liquids.
• Never draw in fl uids containing solvents (e.g., gaso-
• Never direct the water jet at yourself, other persons,
• Never direct the water jet at pets or other animals.
• Never direct the water jet at live electrical equipment
• Hold the spray lance fi rmly with both hands. The spray
• Never start up a frozen machine. Frost damages are
• Always ensure fi rm and safe footing.
• The machine shall be operated in an upright position.
• If the machine is left or not used for 5 minutes, it must
30
pawl is activated, the spray handle cannot be ope-
rated.
ing. The machine will restart after a few minutes when
the thermal sensor has cooled.
system from excessive pressure.
with high pressure.
line, heating oil, paint thinner or acetone) These sub-
stances damage the materials used in the machine.
Their spray is highly combustible, explosive and poi-
sonous.
not even to clean clothing or footwear - risk of injury.
or the machine itself - danger of short-circuiting.
lance is affected by a thrust of up to 27.4 N and a sud-
den torque when activating the trigger of the spray
handle during operation.
not covered by the guarantee!
be switched off on the start/stop switch "O" (1).
WARNING!
Original instructions