Use
Requirements for the set-up location
NOTE!
►
When choosing a location for the appliance, en-
sure that the appliance is not subjected to direct
sunlight, vibration, dust, heat, cold and moisture.
►
Do not set up the appliance in the vicinity of
heat sources, such as radiators.
►
Protect sensitive surfaces before setting up the
product.
♦
Place the appliance on a flat and level surface.
Connecting to a power supply
This device can be operated with batteries or the
mains adapter. For a permanent projection, permanent
display illumination and to use the USB port
the mains adapter
Mains power operation:
♦
Ensure that the On/Off switch for permanent projec-
tion
is in the "OFF" position.
♦
Plug the low voltage plug on the mains adapter
into the connector socket
connect the mains adapter
ble mains plug.
Battery operation:
♦
Open the battery compartment
the appliance by removing the battery compart-
ment cover .
♦
Insert three AAA batteries into the battery compart-
ment
as indicated.
♦
Close the battery compartment
SFPW 360 B1
must be connected.
on the appliance and
to an easily accessi-
on the rear of
again.
GB │ IE
│
,
37
■