ABB Orion1 Extended Bedienungsanleitung Seite 8

Basic configuration mode (BCM)
Warning! The device can enter Basic Configuration Mode during normal operation. As soon as a CONFIRM action is
executed after configuration, the device automatically restarts in Normal Operation with the new configuration.
Particular attention has to be taken during the basic configuration management and use.
Warning! Muting time-out "∞" does not comply with the requirements of IEC 61496-1:2013. Therefore, all possible
risks must be considered and related precautions undertaken before selecting the "∞"option.
Use the special tool, provided with the device, to activate the push-buttons.
RECEIVER CONFIRM SELECT
1. Keep the CONFIRM button pressed to enter the Basic Configuration Mode.
2. Check that you are in BCM: all the LEDs are lit in sequence from 2 to 8 informing you of the current
configuration.
3. Select the function to configure with the SELECT push-button; the corresponding LED flashes.
4. Activate the selected function with the ENABLE push-button (switch LED on/off).
5. Repeat steps 3 and 4 until the desired configuration is visualized.
6. Keep the CONFIRM push-button pressed to activate the new configuration.
Function list on the transmitter
Function
Coding
Range selection
1
The default configuration (at delivery) is indicated in bold characters.
2TLC172296M0201 Rev A
2015-03-20
LEVEL
ENABLE
LED
number
2
3
1
Setting
Code 1
Code 2
No Code
Long
Short
8
LED Status
CODE
1 2 3 4 5 6 7 8
www.abb.com/jokabsafety