Storing Fm Stations Automatically (Autobetical); Direct Tuning - Sony STR-DE475 Bedienungsanleitung

Storing FM Stations
Automatically
This function lets you store up to 30 FM and FM RDS
stations in alphabetical order without redundancy.
Additionally, it only stores the stations with the clearest
signals.
If you want to store FM or AM stations one by one, see
"Presetting radio stations" on page 37.
For details on the buttons used in this section, see "Brief
descriptions of buttons used to receive broadcasts" on
page 35.
1
Press ?/1 to turn off the receiver.
2
Hold down MEMORY and press ?/1 to turn the
receiver back on.
"AUTO-BETICAL SELECT" appears in the display
and the receiver scans and stores all the FM and FM
RDS stations in the broadcast area.
For RDS stations, the tuner first checks for stations
broadcasting the same program, then stores only the
one with the clearest signal. The selected RDS stations
are sorted alphabetically by their Program Service
name, then assigned a two character preset code. For
more details on RDS see page 38.
Regular FM stations are assigned two character preset
codes and stored after the RDS station.
When done, "FINISH" appears in the display
momentarily and the receiver returns to normal
operation.
Notes
• Do not press any of the buttons on the receiver or supplied
remote during autobetical operation.
• If you move to another area, repeat this procedure to store
stations in your new area.
• For details on tuning the stored stations, see page 37.
• The FM MODE setting is also stored along with the station.
• If you move the antenna after storing stations with this
procedure, the stored settings may no longer be valid. If this
happens, repeat this procedure to store the stations again.
36 GB
(AUTOBETICAL)

Direct Tuning

For details on the buttons used in this section, see "Brief
descriptions of buttons used to receive broadcasts" on
page 35.
1
Press TUNER.
The last received station is tuned in.
2
Press FM/AM to select the FM or AM band.
3
Press D.TUNING on the remote.
4
Press the numeric buttons on the remote to enter
the frequency.
Example 1: FM 102.50 MHz
b b b
1 0 2 5
Example 2: AM 1350 kHz
b b b
1
3 5 0
If you cannot tune in a station and the
entered numbers flash
Make sure you've entered the right frequency. If not,
repeat Steps 3 and 4.
If the entered numbers still flash, the frequency is not
used in your area.
5
If you've tuned in an AM station, adjust the
direction of the AM loop antenna for optimum
reception.
6
Repeat Steps 2 to 5 to receive other stations.
z
If you try to enter a frequency not covered by the tuning
interval
The entered value is automatically rounded up or down.
Tuning interval is:
FM: 50 kHz
AM: 9 kHz
b
0