Betriebsanleitung
Problem Solving
Problem
Extra noise or vibration
Reduced runtime or boat
underpowered
Boat does not bind with the
transmitter during binding
www.modster.at
Possible Cause
Damaged propeller, shaft or
motor
Propeller is out of balance
Boat battery level is low
Boat battery is damaged
Blocking or friction on shaft or
propeller
Boat conditions may be too
cold
Battery capacity may be too
low for conditions
Dirve torque is too close
Too little lubrication on shaft
Something blicks the rudder or
propeller
Transmitter is too close to the
boat during linking process
Boat or transmitter is too close
to large metal object
Bind plug is left installed
Transmitter may have veen
bound to a different boat
ESC is switched off
21 / 24
Solution
Replace damaged parts
Balance or replace propeller
Charge the battery completely
Replace battery and follow
battery instructions
Disassemble, lubricate and
correctly align parts
Make sure battery is warm
Replace battery
Loosen coupling at shaft and
move shaft a little
Fully lubricate shaft
REmove boat from the water
and obstacles
Move powered transmitter a
few feet from boat, disconnect
and reconnect battery to boat
Move boat or transmitter away
from the large metal object
Replace / charge battery
Bind boat to transmitter
Switch on ESC
21