Herunterladen Inhalt Inhalt Diese Seite drucken

Modster Vector SR65 Betriebsanleitung Seite 20

Boat
Quelle: modster.at
Vorschau ausblenden Andere Handbücher für Vector SR65:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Betriebsanleitung
Charging Instruction
To charge the supplied lithium battery, use only the enclosed charger or equivalent and
compatible chargers for lithium batteries.
Charging the lithium battery using a non-compatible charger (such as NiCd or NiMH rechargeable
battery chargers) or other non-compatible lithium battery chargers may damage the battery or
fire, causing damage to property and / or personal injury. CAUTION: Be sure to ensure proper
polarization before connecting.
For balance charger & power adaptor set:
1. Connect the included balance charger to the power supply. Then plug the power supply into
a suitable AC power socket and connect the power output cable to the plug on the side of the
charger. The power supply and charger are correctly connected and ready for charging when the
green LED light is lit.
2. Connect the white 4-pin connector of the battery to the appropriate jack on the charger. Note
that even if the white connector minimizes the risk of reversed polarity, it is still possible to
create connections with incorrect polarity due to force or force effects, causing damage to the
battery or charger. If the connectors are in the correct polarity, only a small amount of pressure
should be sufficient to get the click of the secure connection when merging.
3. When the battery and charger are properly connected, both LED lights (red and green) light
up. As long as the red LED light is lit, the battery is charging.
4. It takes about 1.5 - 2.5 hours to recharge a nearly or completely discharged battery. When
the battery is fully charged, the red LED light will stop flashing. When this happens, you can
disconnect the battery from the charger as it is fully charged and ready to use.
Caution: Never store fully charged lithium batteries.
For increased safety and the longevity of the LiPo battery, it is best to store it only partially
charged. A voltage of approximately 50% (3.58 V per cell) is best suited for storage, but it
requires careful management of charging time and the use of a voltmeter to achieve this
voltage.
If you have the necessary equipment and the ability to achieve the 50% voltage for the storage,
this is absolutely recommended. Otherwise, if the battery is stored at room temperature and
for no more than a few weeks until the next use, it is advisable to store the battery completely
discharged (as long as the battery has not been over-discharged during the last use).
20
20 / 24
www.modster.at

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis