Motor Care - Modster Vector SR65 Betriebsanleitung

Betriebsanleitung
CAUTION: DO NOT TURN OFF THE TRANSMITTER BEFORE UNCONNECTING THE BATTERY FROM
THE RECEIVER. OTHERWISE THE RECEIVER MAY PICK UP STRAY SIGNALS AND CAN CAUSE AN
ACCIDENT!
Always store the boat with hatch removed to prevent mold etc. in the hull.
Test Drive in the Water
1. Place the boat in the water.
2. Drive at low speed near the shore. Always avoid objects in the water.
3. As soon as you feel safe when driving slowly, continue driving farther away when the situation
allows to do so.
Tip: If you have too much trim in the steering to steer the boat straight, set the trim to a neutral
position and center the rudder mechanically. You can do this by loosening the button on the
rudder horn, placing it in a suitable position to ensure the rudder is centered.
4. Drive the boat back when you notice that it is driving slower, even though you give maximum
throttle.
Controlling Tips
Keep away from watercraft, solid objects, waves or rapid currents, animals or plants in the water.
Also keep away from areas with many people such as swimming areas, fishing ponds etc. Check
regional laws or regulations before driving in a specific region.
Maximum speed can only be achieved if the water and wind conditions are correspondingly
mild. Sharp curves, wind or waves can cause the boat to tip over. Always adapt your driving style
to the driving conditions. For your first ride we recommend light to no wind and calm water.
ATTENTION: If you drive with full throttle in turbulent water, the propeller could get over and
under water again, which can lead to damage to the propeller.
ATTENTION: Never get your boat out of the water at extreme temperatures, turbulence or
without supervision.

Motor Care

Extend the life of the motor by preventing overheating. Excessive wear occurs from constant
turns, starts and stops or permanent full throttle, or driving in inappropriate conditions as
described above.
Overheat protection is provided by the controller in terms of damage to the circuit, but can not
protect the motor from heavy resistance.
After Driving
1. Turn off the controller
2. Disconnect the battery
3. Turn off the transmitter
4. Remove the batteries from the boat and the transmiter.
Always store the boat with hatch removed to prevent mold etc. in the hull.
18
17 / 24
www.modster.at