Modster Vector SR65 Betriebsanleitung Seite 22

Betriebsanleitung
Problem
Boat tends to dive in water or
takes on water
Boat tends to turn in only one
direction
Rudder does not move
Controls reversed
22
Possible Cause
The boat hull is not completey
closed
Center of gravity is too far
foward
r T m i a t s b a e r n a l g d e n i
on the back of the boat
Rudder or rudder trim is not
centered
Vertical fins of trim tabs are
angled incorrectly
Rudder, linkage or servo
damage
Wire is damged or connections
are loose
Transmitter is not bound
correctly or the incoorect boat
was selected
BEC of ESC is damaged
ESC is off
Transmitter settings are
reversed
22 / 24
Solution
Dry out the boat and ensure
the hatch is fully closed on the
hull before resetting into water
Move batteries back in the hull
Angle each trim tab up a small
o c r r c e y l t amount to lift the bow or down
a small amoutn to lower the
bow
Repair rudder or djust rudder
and rudder trim for straight
running while the control is at
a neutral position
Angle the fins a small amount
to the right or left so that the
boat gows straight when the
rudder is at a neutral position
Replace damaged parts and
adjust the transmitter
Check the wires and
connections, connect or
replace when needed
Rebind or select correct boat in
transmitter
Replace ESC
Switch on ESC
Do the Contro Direction
Test and adjust controls on
transmitter appropriately
www.modster.at