Modster Vector SR65 Betriebsanleitung Seite 23

Betriebsanleitung
Problem
Motor or ESC overheats
Motor power pulses then
motor loses power
Boat does not link to
transmitter (after bindin)
Boat does not respond to
throttle but responds to other
controls
www.modster.at
Possible Cause
Blocked water cooler tubes
ESC uses default soft Low
Voltage Cut Off (LVC)
Weather conditions are too
cold
Battery is old, damaged or
worn out
Battery crating is too small
Transmitter is too near to the
boat during linking process
Boat or transmitter is too close
to a large metal object
Boat or transmitter battery
charge is too low
Transmitter is bound to a
different boat
ESC is switched off
Throttle servo travel is lower
than 100%
Throttle channel is reversed
23 / 24
Solution
Clean or replace water tubes
Do the Control Direction
Test and adjust controls on
transmitter appropriately
Postpone until weather is
warmer
Replace damaged battery
Use the recommended battery
Move powered transmitter a
few feet away, disconnect and
reconnect the battery
Move boat or transmitter away
from the large metal object
Replace/Charge battery
Bind your boat to the
transmitter
Switch ESC on
Make sure throttle channel on
transmitter
Reverse throttel channel on
transmitter
23