Hatco Quick-Therm QTS-1 Serie Installations- Und Bedienungshandbuch Seite 6

IMPORTANT SAFETY INFORMATION
WARNINGS
The unit is not waterproof. DO NOT submerge in water.
To prevent any injury or damage, do not operate if unit
has been submerged in water.
This appliance is not jet-proof construction. Do not use
jet-clean-spray to clean this appliance.
To reduce the risk of fire, the QTS-1 appliance is to be
mounted on a countertop of noncombustible material
and surface finish with no combustible material
against the underside, or on noncombustible slabs or
arches, and have no combustible material against the
underside. Such construction shall in all cases extend
not less than 305 mm (12") beyond the equipment on
all sides.
To assure safe and proper operation, when connecting
unit direct to main terminal block, a 4-pole switch must
be installed between the unit and the main supply. The
switch must be rated properly and have contacts with
a minimum opening distance of 3 mm.
Units supplied with power cord require field
installation of proper electrical plug. For safe and
proper operation the plug must be proper for the
electrical specifications of the unit, power supply and
be grounded.
If the power supply cord is damaged, it must be
replaced by Hatco, an Authorized Service Agent, or a
person with similar qualifications to avoid a hazard.
If service is required on this unit, contact your
Authorized Hatco Service Agent, or contact the Hatco
Service Department at 414-671-6350; International fax
414-671-3976.
This product has no "user" serviceable parts. To avoid
damage to the unit or injury to personnel, use only
Authorized Hatco Service Agents and Genuine Hatco
Replacement Parts when service is required.
Genuine Hatco Replacement Parts are specified to
operate safely in the environments in which they are
used. Some aftermarket or generic replacement parts
do not have the characteristics that will allow them to
operate safely in Hatco equipment. It is essential to use
Hatco Replacement Parts when repairing Hatco
equipment. Failure to use Hatco Replacement Parts
may subject operators of the equipment to hazardous
electrical voltage, resulting in electrical shock or burn.
Form No. QTSCEM-0907
Use only non-abrasive cleaners and pads. Abrasive
cleaners and scouring pads could scratch the finish of
your unit, marring its appearance and making it
susceptible to dirt accumulation.
Do not clean unit with high pressure water or direct
jets. Damage to the unit or malfunctions in operation
may occur.
To avoid any damage to the unit, make sure the
electrical supply matches the voltage and frequency
rating on the specification plate.
4
NOTICES