English
For the customers in Europe
This product with the CE marking complies with the EMC
Directive (89/336/EEC) issued by the Commission of the
European Community.
Compliance with this directive implies conformity to the
following European standards:
• EN55103-1: Electromagnetic Interference (Emission)
• EN55103-2: Electromagnetic Susceptibility (Immunity)
This product is intended for use in the following
Electromagnetic Environment (s):
E1 (residential), E2 (commercial and light industrial), E3
(urban outdoors) and E4 (controlled EMC environment
ex. TV studio)
Table of Contents
Overview ......................................................................... 11
Specifications ................................................................ 17
Overview
The DXBK-701 SDI Output Board is an option board for the
Sony CCU-TX7/TX7P Camera Control Unit. When this board
is fitted in a CCU-TX7/TX7P, it provides an SDI digital signal
output.
Note
This board can be fitted to a CCU-TX7 with serial number
11001 or greater or a CCU-TX7P with serial number 41001 or
greater.
When this board is fitted, the heat generated can cause burns.
Be sure to have the board fitted by your Sony dealer.
..........................................................................................................................
1) Fitting the board to a CCU-TX7 with serial number 11000 or below or a
1)
CCU-TX7P with serial number 41000 or below requires a separate
modification to the CCU-TX7/TX7P. Consult your Sony dealer about
this.
GB
11