Clearaudio TT3 Bedienungsanleitung Seite 15

User manual / Bedienungsanleitung
7.3 Tangential adjustment
Use the lift to lower the stylus at the left hand end of the Clearaudio linear gauge, moving the
gauge so that the diamond sits exactly on the reference line (see Pic. 25, red line). Lift the cartridge
up again and then position it at the right hand end of the gauge.
Pic. 25: Adjustment of the linear tracking
Never move the cartridge while it is lowered in the linear gauge, to avoid any damage.
If the cartridge is not parallel to the reference line, rotate the tonearm base in the appropriate
direction, fix it in place and recheck your result.
Repeat this process until the stylus exactly follows the reference line of the linear gauge.
Finally, hand-tighten the screw/screws of the tonearm base to fix the final adjustment.
For a perfect sound, we recommend checking the tracking force, azimuth and VTA settings again
and correcting them if necessary.
Pic. 26: Supporter of the folding base
Made in Germany
After completing all adjustments, please make sure that the signal
cable forms a smooth loop upwards and that the supports (Pic. 26) of
the folding base are screwed up so that the tonearm gently rests on
them when in the horizontal position.
The Clearaudio TT3
Pic. 25a: Distance between headshell screw and
diamond of the cartridge about 6.2cm / 62mm
tonearm is now fully adjusted and ready to play.
15