Simons Voss Technologies 3068 Kurzanleitung Seite 27

Programme as follows:
1. Enter „0" (longer than 3 sec)
2. Enter „01"
3. Enter „IPIN" (21 digits*)
4. Enter „New user PINvariable"
5. Repeat „New user PINvariable"
*Please use the last 21 digits in the IPIN from the printout.
This means that the user enters their complete 24-digit number and then the user
PINvariable that they chose themselves twice.
The new user PINvariable must feature the corresponding length as specified or
configured according to Section 5.3 Einstellen der USERPIN Länge.
A check is made to ensure that the user PINvariable is not a trivial PIN. If it is, the
system rejects the user PINvariable.
Look at Section 7.1.1 for further information and the format of a full user PIN.
8.0 OPENING
8.1 KNOWLEDGE MODE
Proceed as follows to open the associated lock device using the pin code terminal:
Enter the TID (5 digits) + the programmed PIN. You have a maximum of 5 seconds to
enter each individual number. The LED will flash GREEN twice and an acoustic signal
will sound if you entered the right numbers and programmed the integrated transpon-
der correctly. The integrated transponder will then open the lock device.
27