Safety Instructions - Simons Voss Technologies 3068 Kurzanleitung

1.0 PRODUCT DESCRIPTION
1.1 GENERAL INFORMATION
Pin Code Terminal 3068 is a digital 'key' (transponder) which opens SimonsVoss G2
lock devices after a correct PIN code has been entered using contactless communi-
cation in a wireless network.
At least one PIN needs to be pre-assigned to configure the system and the associ-
ated integrated transponder needs to be programmed for the lock device. After
programming, the lock device can then be released after a correct PIN code has been
entered.
2.0 PRECAUTIONS
2.1

SAFETY INSTRUCTIONS

: : Only trained specialists may fit and install the terminal.
: : Do not allow the pin code terminal to come into contact with oil, paint, acids or
similar.
: : Only use batteries which have been approved by SimonsVoss.
: : Warning: the batteries used in this product may pose a fire or burn hazard if
handled incorrectly. Do not recharge, open or burn these batteries, or heat them
to over 100°C.
: : When replacing the batteries, use clean gloves free of fat or grease to handle new
batteries.
: : Dispose of old and used batteries in the proper manner and store them out of
children's reach.
: : Damage may be caused to the pin code terminal if you reverse the polarity.
: : Always replace all batteries when changing batteries.
: : The pin code terminal must always be operated with two batteries.
: : Do not allow the pin code terminal to become dirty or scratched. Ensure that
the key-pad does not fall onto the floor and is not exposed to any other type of
impact.
: : When replacing the batteries, make sure that the electronics are not subject to
18