Simons Voss Technologies 3068 Kurzanleitung Seite 21

4.2 TIME OUT
If no key is pressed for 5 seconds while the PIN is being programmed, programming is
aborted and an error message displayed. The new PIN is not accepted or the existing
one remains valid and the process must be started again.
4.3 PROCEDURE
To start the programming mode on the pin code terminal, you need to press down „0"
for more than 2 seconds. The programming function is then selected using a code (01
to 99). The corresponding programming functions are described in detail in the follow-
ing sections.
Please always press down a key <>0 for longer than three seconds to start program-
ming with the software.
5.0 PUTTING INTO OPERATION
5.1 GENERAL PROGRAMMING MODE
You need to press down the „0" key for longer than 2 seconds to enter programming
mode. The changeover into programming mode is signalled by the indicator light
flashing yellow briefly and a short tone being emitted.
5.2 CHANGING THE MASTER PIN
When placing the terminal into operation for the first time, you must change the fac-
tory default master PIN 1 2 3 4 5 6 7 8 to a personal master PIN. If the master PIN is
not changed, none of the other functions may be used.
Specifications for the master PIN:
: : 8 digits
: : Please also observe Section 4.1.
A personal master PIN is required for authentication for a variety of programming pro-
cedures. Please keep it in a safe place where it cannot be accessed by unauthorised
21