Lock Device - Simons Voss Technologies 3068 Kurzanleitung

6.2 PROGRAMMING THE LOCKING SYSTEM DATA
6.2.1 PIN CODE TERMINAL
The pin code terminal only needs to be programmed with the locking system data
once.
Programme as follows:
1. Edit -> Locking system properties
2. Select „PIN code terminal" tab
3. Select „Operating type" (see Section 7.0 MODI)
4. Define „PIN code length"
5. Click to accept
6. Select "Programme / Reset"
7. Highlight corresponding lock device under „Doors with PIN code terminals"
8. Launch programming command in the software („Programming" button)
9. Hold down any key (except the „0"*) on the pin code terminal for 3 seconds
*CAUTION: LSM 3.1 SP1 currently asks you to press „0" as well. However, any key
can be used except „0".
6.2.2 PIN CODE USER
Add all users or transponders as a „PIN code user" in „Knowledge mode"; there is no
need for an additional transponder in this mode.

6.2.3 LOCK DEVICE

Before programming the lock device, it is recommended to add all users as a „PIN
code user" first and only then programme the lock device. If you do not, new users for
the fitted lock device will need to be programmed again.
Recommended: in order to minimise or completely avoid programming at the door in
an installed locking system, proceed as follows:
a) Create transponder group (e.g. pin code terminal)
b) Add transponder (type: PIN code user)
24