Simons Voss Technologies 3068 Kurzanleitung Seite 22

persons.
1. Enter"0" -> (press down for longer than 2 seconds)
2. Enter „09"
3. Enter „Default master PIN"
4. Enter „New master PIN"
5. Repeat „New master PIN"
If no key is pressed for 5 seconds while the PIN is being programmed, programming
is aborted and an error message displayed. The existing master PIN remains valid and
the process must be started again.
If you wish to change an existing master PIN, please use the same procedure de-
scribed above. You should enter the current master PIN when asked to enter the
„Default master PIN".
5.3 SETTING THE USER PIN LENGTH
The system administrator is able to specify the user PIN length just once for the whole
system when placing the terminal into operation. This length can be set at between 4
and 8 digits and will apply to all PINs. The master PIN always features 8 digits.
Please proceed as follows:
1. Open locking system
2. Open the pin code terminal configuration (Edit -> Locking system properties ->
PIN code terminal)
3. Select PIN length under „PIN code length"
4. Confirm by pressing „Accept".
CAUTION: the user PIN length cannot be changed once the first pin code terminal in
the locking system has been programmed, otherwise all terminals in the system must
be reprogrammed, new PINs must be issued and so on.
22